NEW: High-ratio servo gearbox

28.07.2021

The new VCE servo gearboxes are available in the four sizes 065 - 090 - 120 - 140 and in a ratio ranges from 1:1 to 400:1 in the usual high product quality and a short delivery time. The multi-stage combination gearboxes consisting of bevel and planetary gearboxes are high-precision and highly dynamic servo drive solutions.

Servogetriebe VCEzoom

Your advantages:

  • Sizes 065 - 090 -120 - 140
  • Transmission ratio ranges from 1:1 to 400:1
  • High-precision and highly dynamic servo drive solution
  • High torsional stiffness
  • Low circumferential backlash
 

Downloads

 

General technical information

Gearbox Planetary Gearbox Bevel Gearbox
Gear teeth Straight teeth Helical teeth
Ratios 4:1 to 100:1 1:1 to 6:1
Housing Aluminium / Steel Cast iron / Steel
Sealing 2 RS-bearing seals Shaft seal
Lubrication Grease Oil
General
Life span (L 10h) > 15.000 h
Operating temperature -10 °C / +90°C
Protection class IP 54
Operating mode S1, S2, S3
Corrosion protection Primer: Layer thickness > 40 μm
Maintenance intervals None
 
 

Variants at a glance

Einstufiges Kombinationsgetriebe aus Kegelrad– und Planetengetriebezoom

Due to the new design, the single-stage version has an e dimension that is up to 20% shorter. In addition, the gearbox is optimised in terms of weight and performance.

The gearbox is impressive with high precision, high torsional stiffness, low circumferential backlash, optimised temperature control and the simultaneous use of the existing PCE motor flanges.

Depending on the application, you can choose the combination that suits you best from the four different sizes and up to seven gear ratios.

Mehrstufiges Kombinationsgetriebe aus Kegelrad– und Planetengetriebezoom

The modular design of the drive neck using the well-known ATEK planetary gear enables a gear ratio of up to 400:1 for the multi-stage variant.

The combination is impressive with its high torsional stiffness and low circumferential backlash.

Depending on the application, there are four different sizes and nineteen gear ratios to choose from.

 

Flohr Industrietechnik GmbH - Im Unteren Tal 1 - D-79761 Waldshut-Tiengen - Phone: +49 (0)7751 / 8731-0 - info@flohr-industrietechnik.de

Privacy policy

Our web site uses external components. These help us to constantly improve our offer and to provide you with a comfortable visit. By loading external components, data about your behavior may be collected by third parties, which is why we need your permission. Without your permission, there may be restrictions on content and operation. You can find detailed information in our Privacy policy.