Rigid coupling

The rigid couplings GRI have been designed and manufactured to connect two shafts of the same diameter but without allowing any relevant misalignment. The coupling is manufactured in one element for the single split version. A two piece unit is available on request allowing simple and fast mounting and dismounting.

Dimensioning

The nominal torque of the coupling must be higher than the maximum torque of the motor's side. The indicated torque values have been calculated based on a friction coefficient for shaft-coupling of 0.15 µm.

Fitting

• Surface finish with Ra=1.6 µm
• Nominal tolerance h6
• Perfectly aligned shafts.
  

Short info

• Made in steel fully turned with phosphating treatment
• Extremely rigid connection
• High torque possible
• Wear and maintenance free
• Compact dimensions
• Finished bore with ISO H8 tolerance and Ra=1.6 mm roughness
  
• Up to 1,420 Nm and 50 mm bore diameters

On request

• Made in steel fully turned with phosphating treatment
• Extremely rigid connection
• High torque possible
• Wear and maintenance free
• Compact dimensions
• Finished bore with ISO H8 tolerance and low roughness