2-part shrink discs (displacement-controlled) are external clamping
elements consisting of a pressure ring and a sleeve. By tightening the
clamping screws with a specified screw tightening torque, the pressure
ring is pulled axially onto the sleeve. The use of conical surfaces
reduces the inner diameter of the sleeve, which applies a radial
clamping force to the hollow shaft. The clamping force applied by the
shrink disc connection creates a frictional connection at the contact
surfaces between the shaft and hub. 2-part shrink discs have a smaller
cone angle compared to 3-part shrink discs, this value is in the
self-locking.
Due to the small cone angle, it is necessary for the sleeve to have additional push-off threads. With the help of these push-off threads, the pressure ring and sleeve can be easily pressed apart during disassembly. 2-piece shrink discs (displacement-controlled) have a defined displacement, which means that assembly can be carried out also without a torque wrench. The clamping screws of the 2-part shrink disc (displacement-controlled) are tightened evenly in sequence until the face of the sleeve is flush with the face of the pressure ring. The torques specified in the catalog can be transmitted as soon as this assembly condition is reached.
2-part shrink discs have a smaller cone angle compared to the 3-part
version, this is located in the self-locking. Due to the small cone
angle, it is necessary for the sleeve to have additional impression
threads. With the help of these impression threads, the thrust collar
and sleeve can be easily pressed apart during disassembly.
Mini-Series
(3173)
Standard-Series
(3371)
Standard-Series verstärkt (3381)
Heavy Series
(3391)
Heavy Series strenghtened (3393)
2-piece shrink discs (displacement-controlled) can transmit 20%-30% higher torques and are offered in three different versions:
For very small torques and small installation spaces, the TAS 3173 series is suitable.
For high to very high transmittable torques, you can choose between the TAS 3381 and the TAS 3393.
In addition, stainless variants, such as the two-piece shrink disc 3173 1.4122, are available.
Depending
on the installation space available to you and the required torque, we
will work together to find the right solution for you. We can also offer
appropriate solutions for special corrosion protection or low
temperature environments.
It is installed by sliding the shrink
disc onto the hollow shaft and the
subsequent tightening of the screws.
By using conical surfaces the inner
diameter reduces and the radial
pressure is built up. The 33xx range
of shrink discs are self-locking.
The clamping forces are provided
through the screws.
They are controlled by path (front
faces are flush).
The supplied shrink discs are ready
for installation.
To achieve proper operation
with a sufficiently high coefficient
of friction, the contact surfaces
between shaft and hub must be
dry, clean and free of grease.
The
functional surfaces of the shrink disc,
the thread and head rests of the
screws, are equipped at the factory
with lubricant. Molykote G-Rapid
Plus or comparable must be used
as a lubricant. The contact surfaces
between the hub and the bush must
be provided with grease or oil before
installation
In combination with the simplified handling, the 2-part shrink discs
(displacement controlled) have proven themselves in practice, especially
in the field of mining and materials handling. However, these shrink
discs are used as standard in the entire area of frictionally engaged
shaft-hub connections, e.g. in drive technology, the oil and gas
industry, the timber industry or hollow shaft gearboxes.
Flohr Industrietechnik GmbH - Im Unteren Tal 1 - D-79761 Waldshut-Tiengen - Phone: +49 (0)7751 / 8731-0 - info@flohr-industrietechnik.de