Motor base MW 10

The MW 10 motor base is suitable for belt drives with motors from 37 kW to 200 kW. Depending on the specifications of the drive system, the base can be infinitely adjusted via a single, maintenance-free, centralised pretensioning unit equipped with axial ball bearings. The mounting holes of the motor and base plate are identical and suitable for all motor housing sizes (IEC 250S - 315M / NEMA 404T - 447T). In addition, the compact design enables easy installation even in existing systems with limited space.

The use of the MW 10 motor base guarantees optimum belt tension at all times thanks to its self-regulating function. This means minimal maintenance and maximum efficiency thanks to belt-friendly operation with optimum traction.

• V-belt replacement time is massively reduced
• No need to realign the two drive pulleys when changing the belt
• Significantly longer belt service life due to correct tension
• Fewer operational interruptions and protection of the drive pulleys, bearings and motor axles
• Less energy consumption and higher performance thanks to optimally tensioned drive belts
• Maintenance-free

Standard installation of the motor base

These recommendations are based on practical experience. A test run shows the ideal installation position. All motor plates have an "offset" of 100 mm.

The motor base MW 10 should be pre-tensioned using the central pre-tensioning device in accordance with the test force specified by the belt manufacturer.
Exception: In the case of vibrating screens, the belts should only be tensioned to such an extent that friction is guaranteed at all times.